Cisco SR2016T-NA Reference Manual page 1131

Chapter 6 Cable CPE Commands
show controllers cable-modem service-flows
To display the service flows that are configured on the router, use the show controllers cable-modem
service-flows command in privileged EXEC mode.
Cisco uBR905, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description number
sfid
summary
Command Modes Privileged EXEC
Command History Release
12.2(15)CZ
Usage Guidelines This command displays the Quality of Service (QoS) parameters that make up each of the service flows
that are defined on the router for the upstream and downstream. The information shown corresponds to
the QoS parameters that are listed in Appendix C of the DOCSIS 1.1 specification.
Examples The following example shows typical output for the default form of the show controllers cable-modem
service-flows command.
Router# show controllers cable-modem 0 service-flows
Upstream Flow Scheduler Parameters
Flow Type: Primary
Flow Reference:
Service Flow ID:
Service ID:
QoS Set Type:
QoS Traffic Priority:
QoS Max Sustained Traffic Rate: 0
QoS Max Traffic Burst:
QoS Min Reserved Traffic Rate:
QoS Min Reserved Rate Pkt Size: 0
QoS Timeout For Active Param:
Qos Timeout For Admitted Param: 200
Max Concatenated Burst:
Scheduling Type:
Request/Transmission Policy:
Nominal Polling Interval:
Tolerated Poll Jitter:
OL-1581-07
show controllers cable-modem number service-flows [sfid | summary]
Identifies the cable interface (always 0).
(Optional) Displays detailed information for a specific service flow, as
identified by its service flow ID (SFID). The valid range for sfid is 1 to
2147483647.
(Optional) Displays a summary report of all service flows.
Modification
This command was introduced for the Cisco uBR905 and Cisco uBR924
cable access routers, and the Cisco CVA122 Cable Voice Adapter.
show controllers cable-modem service-flows
1
3
2
7
0
1522
0
0
0
0x2
0x0
0
0
Cisco Broadband Cable Command Reference Guide
6-129