ip address docsis
Examples
The following example shows how to configure the cable access router so that it obtains the IP address
for its cable interface from a DHCP server:
Router(config)# interface cable-modem 0
Router(config-if)# ip address docsis
Router(config-if)# exit
Router(config)#
Related Commands
Command
cable-modem dhcp-proxy
ip http dhcp
ip http negotiated
Cisco Broadband Cable Command Reference Guide
6-54
Description
Specifies that a DHCP server should provide the IP address for the
router's Ethernet interface or for a NAT address pool.
Specifies the use of the DHCP protocol to obtain an IP address for
any interface except the cable interface at system power-on.
Specifies that a serial interface should use the PPP/IPCP to obtain
an IP address at system power-on
Chapter 6
Cable CPE Commands
OL-1581-07