Cisco SR2016T-NA Reference Manual page 969

Chapter 5 Cisco CMTS Debugging Commands
debug hccp sync
To display debugging messages for HCCP SYNC activity, use the debug hccp sync command in
privileged EXEC mode. To disable the debug message output, use the no form of the command.
Syntax Description
cable
bpi
classifier
cm
cpe-management
host
offered-band
phs
qosparam
ranged-list
service-flow
sid
tlvs
ucd
Command History Release
12.1(3a)EC
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC1
OL-1581-08
debug hccp sync
debug hccp sync cable [bpi | classifier | cm | cpe-management | host | phs | qosparam |
ranged-list | service-flow | sid | tlvs | ucd]
no debug hccp sync
no debug hccp sync cable [bpi | classifier | cm | cpe-management | host | phs | qosparam |
ranged-list | service-flow | sid | tlvs | ucd]
(Optional) Displays debugging for SYNC messages on the cable interface.
(Optional) Displays debugging for SYNC messages about BPI configuration
and operation.
(Optional) Displays debugging for SYNC messages about classifier
coordination.
(Optional) Displays debugging for CM-related SYNC messages.
(Optional) Displays debugging for SYNC messages that concern
CPE-related parameters, such as MAX CPE, MAX CPE IP, and max
learnable addresses.
(Optional) Displays debugging for host-related SYNC messages.
(Optional) Displays debugging messages for CMTS-generated offered band
messages.
(Optional) Displays debugging for SYNC messages about PHS values.
(Optional) Displays debugging for SYNC messages about QoS and service
templates.
(Optional) Displays debugging for SYNC messages about ranged list
messages.
(Optional) Displays debugging for SYNC messages about service flows.
(Optional) Displays debugging for SYNC messages that concern service IDs
(SIDs).
(Optional) Displays any type, length, or value errors in SYNC messages.
(Optional) Displays debugging for SYNC messages that concern DOCSIS
upstream channel descriptor (UCD) messages.
Modification
This command was introduced.
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router. Also, the cable message-specific options were added to allow the
debugging of a particular set of messages without overloading the console.
The offered-band option was added to add in debugging problems with
blind-hopping.
Cisco Broadband Cable Command Reference Guide
debug hccp sync
5-109