Cisco SR2016T-NA Reference Manual page 1133

Chapter 6 Cable CPE Commands
The following example shows typical output for the show controllers cable-modem service-flows
command, when displaying information for individual service flows:
Router# show controllers cable-modem 0 service-flows 3
Upstream Flow Scheduler Parameters
Flow Type: Primary
Flow Reference:
Service Flow ID:
Service ID:
QoS Set Type:
QoS Traffic Priority:
QoS Max Sustained Traffic Rate: 0
QoS Max Traffic Burst:
QoS Min Reserved Traffic Rate:
QoS Min Reserved Rate Pkt Size: 0
QoS Timeout For Active Param:
Qos Timeout For Admitted Param: 200
Max Concatenated Burst:
Scheduling Type:
Request/Transmission Policy:
Nominal Polling Interval:
Tolerated Poll Jitter:
Unsolicited Grant Size:
Nominal Grant Interval:
Tolerated Grant Jitter:
Grants Per Interval:
IP TOS Overwrite:
Router# show controllers cable-modem 0 service-flows 4
Downstream Flow Scheduler Parameters
Flow Type: Primary
Flow Reference:
Service Flow ID:
Service ID:
QoS Set Type:
QoS Traffic Priority:
QoS Max Sustained Traffic Rate: 0
QoS Max Traffic Burst:
QoS Min Reserved Traffic Rate:
QoS Min Reserved Rate Pkt Size: 0
QoS Timeout For Active Param:
Qos Timeout For Admitted Param: 200
Max DS Latency:
Router#
Table 17
the QoS parameters that are listed in Appendix C of the DOCSIS 1.1 specification.
Table 17
Field
Flow Type, Sf type
Flow Reference, Sf Ref
OL-1581-07
describes the significant fields shown by this command. The information shown corresponds to
show controllers cable-modem service-flows Field Descriptions
Description
Identifies whether the type of service-flow:
Primary—The primary service-flow for the upstream or downstream.
•
Static—A permanent secondary service-flow.
•
• Dynamic—A dynamically created secondary service-flow.
The service flow reference ID that is used to establish the Service Flow ID.
show controllers cable-modem service-flows
1
3
2
7
0
1522
0
0
0
0x2
0x0
0
0
0
0
0
0
0xFF 0x0
5
4
0
7
0
1522
64000
0
0
Cisco Broadband Cable Command Reference Guide
6-131