Table of Contents
Advertisement
show controllers cable-modem mac
Table 6-11 show controllers cable-modem mac resets Field Descriptions (continued)
Message
CMAC_LOG_RESET_T3_RETRIES_EXHAUSTED
CMAC_LOG_RESET_RANGING_ABORTED
CMAC_LOG_RESET_NO_MEMORY
CMAC_LOG_RESET_CANT_START_PROCESS
CMAC_LOG_RESET_CONFIG_FILE_READ_FAILED
CMAC_LOG_RESET_AUTHENTICATION_FAILURE
CMAC_LOG_RESET_SERVICE_NOT_AVAILABLE
CMAC_LOG_RESET_T6_RETRIES_EXHAUSTED
CMAC_LOG_RESET_MAINTENANCE_WATCHDOG_DRIVER
CMAC_LOG_RESET_NET_ACCESS_MISSING
CMAC_LOG_RESET_FAILED_WRITE_ACCESS_CONTROL
CMAC_LOG_RESET_DHCP_FAILED
CMAC_LOG_RESET_CANT_START_DS_TUNER_PRCESS
CMAC_LOG_RESET_TOO_MANY_DS_LOCKS_LOST
CMAC_LOG_RESET_NO_SEND_TO_DS_TUNER_PROCESS
CMAC_LOG_RESET_DS_TUNER_WATCHDOG
CMAC_LOG_RESET_UNABLE_TO_SET_MIB_OBJECT
CMAC_LOG_RESET_MIB_OBJECT_PROCESS_WATCHDOG
Cisco Broadband Cable Command Reference Guide
6-102
Description
The CMTS failed too many times to respond to a RNG-REQ
message.
After 16 T3 timeouts, the router will reset the cable
Note
interface.
The CMTS commanded the router to abort the ranging process.
The router has run out of memory.
The router was unable to start an internal process necessary to
complete ranging and registration.
The reading of the configuration file from the TFTP server failed.
The file might not exist, or it might have incorrect
Note
permissions.
The router failed authentication as indicated in a REG-RSP message
from the CMTS.
The CMTS has failed the router's registration because a required or
requested class of service is not available.
The CMTS failed too many times to respond to a REG-REQ
message.
The router MAC layer failed to detect a change in the interface
driver.
The Network Access parameter is missing from the DOCSIS
configuration file.
The router was unable to set the Write Access Control for an SNMP
parameter as specified by the DOCSIS configuration file.
The DHCP server did not respond with all the required values. The
required values are: IP address, network mask, TFTP server IP
address, TOD server IP address, DOCSIS configuration file name,
and time zone offset.
The router was unable to start the internal process used to manage
the downstream tuner.
Downstream QAM/FEC lock has been lost too many times.
The router MAC-layer process was unable to communicate with the
downstream tuner management process.
The downstream tuner process failed to report its continuing
operation for a long period of time.
The router was unable to set an SNMP parameter as specified by the
DOCSIS configuration file.
The internal MIB object took too long to process the entries in the
DOCSIS configuration file.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
