Table of Contents
Advertisement
hccp working
Table 2-15
Cisco uBR-MC16S card.
Table 2-18 Switchover Operation for a Cisco uBR-MC16C/Cisco uBR-MC16S Configuration
Working Cable
Interface
Cisco uBR-MC16C Cisco uBR-MC16S The protect card (Cisco uBR-MC16S) uses the same
Cisco uBR-MC16S Cisco uBR-MC16C The protect card (Cisco uBR-MC16C) uses the same
Cisco uBR-MC16S Cisco uBR-MC16S The protect card initially uses the same upstream frequency
Examples
The following example shows cable interface 4/0 being designated as a Working CMTS interface as
member number 2 of group 2:
Router(config)# interface cable 4/0
Router(config-if)# hccp 2 working 2
Related Commands
Command
hccp protect
show hccp
show hccp interface
Cisco Broadband Cable Command Reference Guide
2-440
shows how a switchover affects the enhanced spectrum management features of the
Protect Cable
Interface
Description
Configures a particular cable interface to protect another cable interface in
the same group.
Displays information for all cable interfaces on which one or more HCCP
groups and authentication modes have been configured.
Displays group information for a specific cable interface on which one or
more groups and authentication modes have been configured.
Chapter 2
Operation After Switchover
upstream frequency as the working card, but after the
system stabilizes, the protect card begins using the
enhanced spectrum management features of the
Cisco uBR-MC16S card, as configured on the protect
CMTS.
upstream frequency as the working card. If the upstream
becomes unstable, the Cisco uBR-MC16C performs only
blind frequency hopping.
as the working card, but after the system stabilizes, the
protect card continues using the enhanced spectrum
management features of the Cisco uBR-MC16S card.
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
