Cisco SR2016T-NA Reference Manual page 993

Chapter 5 Cisco CMTS Debugging Commands
debug packetcable subscriber
To enable PacketCable debugging for a specific subscriber IP address or subnet, use the debug
packetcable subscriber command in privileged EXEC mode. To turn off Packetcable debugging for a
particular IP address or subnet, use the no form of this command.
Syntax Description ip-address
mask
verbose
Command Modes
Privileged EXEC
Command History Release
12.2(15)BC1
Usage Guidelines
This command enables debugging for one or more specific PacketCable subscribers. This command by
itself does not generate any debugging output, but enables debugging output for the other debug
packetcable commands.
In Cisco IOS Release 12.2(15)BC1 and later releases, you must use the debug packet subscriber
command to enable debugging for at least one IP address before the following debug packetcable
commands will generate output:
•
•
•
•
•
•
You do not need to use the debug packetcable subscribe command before using the debug packetcable
Note
cops and debug packetcable gate events process commands because these display information that is
not subscriber-specific.
OL-1581-08
debug packetcable subscriber ip-address [mask] [verbose]
no debug packetcable subscriber ip-address [mask] [verbose]
IP address for which PacketCable debugging should be enabled.
Subnet mask to use for this IP address. The router uses this mask to
determine the scope of the IP addresses to be debugged. The default is
255.255.255.255 to indicate the IP address is a specific, single IP address.
Displays detailed information as part of the debug messages, such as the
contents of a PacketCable headers and messages.
Note
Modification
This command was introduced for the Cisco uBR7200 series universal
broadband router.
debug packetcable gate commit
debug packetcable gate control
debug packetcable gate database
debug packetcable gate docsis-mapping
debug packetcable gate events
debug packetcable ipc
The verbose option replaces the detail option that appeared in
previous versions of the other debug packetcable command.
Cisco Broadband Cable Command Reference Guide
debug packetcable subscriber
5-133