Table of Contents
Advertisement
Cisco CMTS Show Commands
This section describes the cable-specific show commands for the Cisco Cable Modem Termination
System (CMTS) universal broadband routers. Refer to the following sections for more information:
•
•
•
Tip
This section documents only cable-specific show commands. For non-cable-specific commands, see the
command reference documentation for
Documentation CD-ROM. For information about debugging commands for the Cisco CMTS routers, see
Chapter 5, "Cisco CMTS Debugging Commands."
Supported Platforms and Cisco IOS Releases
The Cable CMTS show commands operate on the following Cisco CMTS platforms:
•
•
•
Table 3-1
Note
Not all Cisco IOS releases support all Cisco CMTS platforms. See the release notes for each Cisco IOS
release for details on which platforms are supported.
OL-1581-08
Supported Platforms and Cisco IOS Releases, page
Cisco IOS releases that support the commands listed in this section.
Overview of the Operation of the Cable Show Commands, page
the show commands operate on the Cisco CMTS routers using different cable interface line cards.
CMTS Show Commands, page
configure and maintain the Cisco CMTS features.
Cisco uBR7100 series universal broadband routers (the Cisco uBR7111, the Cisco uBR7111E, the
Cisco uBR7114, and the Cisco uBR7114E)
Cisco uBR7200 series universal broadband routers (the Cisco uBR7223, the Cisco uBR7246, and
the Cisco uBR7246 VXR)
Cisco uBR10012 universal broadband routers
shows the minimum supported Cisco IOS releases documented at time of this publication.
C H A P T E R
3-1—Describes the Cisco CMTS routers and
3-4—Describes the cable-specific show commands that are used to
Cisco IOS Release
12.2, available on
Cisco Broadband Cable Command Reference Guide
3
3-3—Provides an overview of how
Cisco.com
and the
3-1
Advertisement
Table of Contents
