Table of Contents
Advertisement
Chapter 4
Commands for the Cisco uBR10012 Router
show facility-alarm status
To display the current temperature thresholds that will trigger a facility alarm, use the show
facility-alarm status command in user EXEC or privileged EXEC mode.
Syntax Description
This command has no keywords or arguments.
Defaults
No default behavior or values
Command Modes
User EXEC, Privileged EXEC
Command History
Release
12.2(1)XF1
Examples
The following example shows a typical display of the show facility-alarm status command:
Router# show facility-alarm status
Thresholds:
Intake minor 40 major 49 Core minor 45 major 53
SOURCE:RPR REDUNDANCY TYPE:Secondary failure SEVERITY:Minor ACO:Normal
Router#
The show facility-alarm status does not show the critical alarm temperature thresholds. You can display
Note
these values using the show running-config | include facility command. If this does not display any
commands for critical alarms, then the temperature thresholds are set at their default values.
Related Commands
Command
clear facility-alarm
facility-alarm
OL-1581-08
show facility-alarm status
Modification
This command was introduced for the Cisco uBR10012 router.
Description
Clears some or all of the facility alarms on the Cisco uBR10012 router.
Sets the temperature thresholds at which the processor generates a critical,
major, or minor alarm to warn of potential equipment damage.
Cisco Broadband Cable Command Reference Guide
show facility-alarm status
4-51
Advertisement
Table of Contents
