Table of Contents
Advertisement
voice-port
voice-port
To enter voice-port configuration mode, use the voice-port command in global configuration mode.
Cisco uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description:
number
Defaults
No default behavior or values.
Command Modes
Global configuration
Command History
Release
12.0(4)XI1
12.1(5)XU1
12.2(2)XA
Usage Guidelines
Use the voice-port global configuration command to enter voice-port configuration mode. Use the exit
command to exit the voice-port configuration mode and return to the global configuration mode. See the
Cisco IOS Multiservice Applications Command Reference, available on Cisco.com and the
Documentation CD-ROM for a list of subcommands that are supported by the voice-port command.
Examples
The following example shows how to enter the voice-port configuration mode for port 0, the first voice
port (labeled "V1+V2") on the router.
Router# configure terminal
Router(config)# voice-port 0
Router(config-voice-port)#
Related Commands
Command
dial-peer voice
Cisco Broadband Cable Command Reference Guide
6-182
voice-port number
Identifies the voice port. Valid entries are 0 (which corresponds to the RJ-11
connector labeled V1) and 1 (which corresponds to the RJ-11 connector
labeled V2).
Modification
Support was added for the Cisco uBR924 cable access router.
Support was added for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
Description
Enters dial-peer configuration mode, defines the type of dial peer,
and defines the tag number associated with a dial peer.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
