Table of Contents
Advertisement
show interface cable service-flow
Table 3-57
Field
QoS Parameter Index Adm
QoS Parameter Index Act
Type
Dir
Curr State
Active Time
Per normal operation, the counter in
Note
service flows. For upstream service flows, the classifier match count is not updated for upstream packet
classifiers, and displays no results.
Router# show interface c6/0 service-flow 30191 verbose
Sfid : 30191
Mac Address : 000a.739e.140a
Type : Secondary(Dynamic)
Direction : Upstream
Current State : Active
Current QoS Indexes [Prov, Adm, Act] : [0, 24, 24]
Active Time : 00:55
Sid : 7140
Admitted QoS Timeout : 200 seconds
Active QoS Timeout : 0 seconds
Packets : 1824
Bytes : 466944
Rate Limit Delayed Grants : 0
Rate Limit Dropped Grants : 0
Current Throughput : 68356 bits/sec, 32 packets/sec
Classifiers:
Classifier Id : 41
Service Flow Id : 30191
CM Mac Address : 000a.739e.140a
Direction : upstream
Activation State : active
Classifier Matching Priority : 128
PHSI : 1
Number of matches : -
IP Classification Parameters:
IP Source Address : 10.8.230.3
Source IP Address Mask : 255.255.255.255
Destination IP Address : 172.16.2.35
Destination IP Address Mask : 255.255.255.255
IP Protocol Type : 17
Source Port Low : 53456
Source Port High : 53456
Destination Port Low : 7052
Destination Port High : 7052
Cisco Broadband Cable Command Reference Guide
3-230
show interface cable service-flow Field Descriptions (continued)
Description
Identifies the QoS parameter index for the Admitted state of this
flow.
Identifies the QoS parameter index for the Active state of this flow.
Indicates if the service flow is the primary flow or a secondary
service flow. Secondary service flows are also identified by an "S"
(created statically at the time of registration, using the DOCSIS
configuration file) or "D" (created dynamically by the exchange of
dynamic service messages between the CM and CMTS).
Indicates if this service flow is downstream (DS) or upstream (US).
Indicates the current run-time state of the service flow.
Indicates the length of time this service flow has been active.
Number of Matches
Chapter 3
Cisco CMTS Show Commands
field is not initialized for working dynamic
OL-1581-08
Advertisement
Table of Contents
