Table of Contents
Advertisement
Chapter 3
Cisco CMTS Show Commands
show cable subscriber-usage
To display subscribers who are violating their registered quality of service (QoS) profiles, use the show
cable subscriber-usage command in privileged EXEC mode.
Syntax Description
over-consume
cable slot/port
cable slot/subslot/port
upstream port
sort-byte-count
Defaults
All subscribers are shown, with the display sorted by SFID.
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
The show cable subscriber-usage command displays the current usage statistics for all subscribers on
the Cisco CMTS, all subscribers on a particular cable interface, or for only those subscribers that are
marked as over-consuming bandwidth.
OL-1581-08
show cable subscriber-usage [over-consume]
[ {cable slot/port | cable slot/subslot/port}[upstream port] ] [sort-byte-count]
Modification
This command was introduced.
(Optional) Displays only those subscribers who have exceeded their
maximum allowed bandwidth.
(Optional) Identifies a cable interface and downstream port on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can
be 0 or 1, depending on the cable interface.
(Optional) Identifies a cable interface on the Cisco uBR10012 router.
The following are the valid values:
•
slot = 5 to 8
subslot = 0 or 1
•
port = 0 to 4 (depending on the cable interface)
•
(Optional) Displays information for a particular upstream on the
selected cable interface. The port value starts with 0 and continues up,
depending on the type of cable interface card.
(Optional) Sort the list by the subscriber byte count, with the highest
byte counts listed first. The default is to sort the list by Service Flow
ID (SFID).
Cisco Broadband Cable Command Reference Guide
show cable subscriber-usage
3-157
Advertisement
Table of Contents
