Cisco SR2016T-NA Reference Manual page 817

Chapter 4 Commands for the Cisco uBR10012 Router
Table 4-3
Field
Packets
Bytes
The following example shows a typical display for the show pxf cable source-verify command:
Router# show pxf cable source-verify
IP Address
50.1.1.3
50.1.1.29
50.1.1.32
50.1.2.6
50.1.2.19
Router#
Table 4-4
Table 4-4
Field
IP Address
Interface
FIB Index
Mac-Domain
SID
Related Commands Command
cable source-verify
clear pxf
debug pxf
show pxf cable
interface
show pxf cpu
show pxf microcode
show pxf xcm
OL-1581-08
show pxf cable multicast-echo Field Descriptions
Description
Number of packets sent to this address.
Number of bytes sent to this address.
Interface Fib Index
Cable5/0/0 0
Cable5/0/0 0
Cable5/0/0 0
Cable8/0/0 0
Cable8/0/0 0
describes the fields shown by the show pxf cable source-verify command:
show pxf cable source-verify Field Descriptions
Description
Identifies the IP addresses that have been verified by the source-verify
feature.
Identifies the cable interface or subinterface used for this IP address.
Identifies the forwarding information base (FIB) being used.
Identifies the MAC DOCSIS downstream domain for this IP address.
Identifies the service ID (SID).
Description
Enables verification of IP addresses for CMs and CPE devices on the
upstream.
Clears the direct memory access (DMA) and error checking and correcting
(ECC) error counters on the PXF processor.
Enables debugging of the PXF subsystems on the active PRE1 module on
the Cisco uBR10012 router.
Displays display DOCSIS-related information about a particular service ID
(SID) on a particular cable interface.
Displays the display different statistics about the operation of the CPU
processor during PXF processing.
Displays identifying information for the microcode being used on the
processor.
Displays the current state of error checking and correcting (ECC) for the
External Column Memory (XCM) on the PXF processor.
Mac-Domain SID
0 1
0 2
0 2
6 1
6 1
Cisco Broadband Cable Command Reference Guide
show pxf cable
4-57