Table of Contents
Advertisement
Chapter 5
Cisco CMTS Debugging Commands
debug cable flap
To display information about the operation of the CM flap list that is maintained for the cable interfaces,
use the debug cable flap command in Privileged EXEC mode. To disable debugging output, use the no
form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Release
11.3(8)NA, 12.0(4)T
12.0(6)SC
12.1(5)EC
12.2(4)BC1
12.2(11)BC2
Usage Guidelines
This command shows debugging messages about the internal configuration file editor on the Cisco
CMTS. For more information about the internal configuration file editor, see the
command and its subcommands.
The debug commands are primarily intended for use in controlled test and troubleshooting situations
Caution
with a limited volume of traffic.
Examples
The following example shows how to enable debugging for the internal configuration file editor:
Router# debug cable flap
CMTS flap debugging is on
Router# show debug
CMTS:
CMTS flap debugging is on
Router#
OL-1581-08
debug cable flap
no debug cable flap
Modification
This command was introduced for Cisco uBR7200 series routers.
Support for this command was added to the Release 12.0 SC train.
Support for this command was added for the Cisco uBR7100 series
routers.
Support was added to the Release 12.2 BC train.
Support for this command was added to the Release 12.2 BC train.
Cisco Broadband Cable Command Reference Guide
debug cable flap
cable config-file
5-35
Advertisement
Table of Contents
