Cisco SR2016T-NA Reference Manual page 870

debug cable bpiatp
debug cable bpiatp
To enable debugging of the Baseline Privacy Interface (BPI) handler, use the debug cable bpiatp
command in privileged EXEC mode. To disable debugging output, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History Release
11.3 XA
Usage Guidelines
This command activates debugging of the BPI feature. When this command is activated, the
Cisco CMTS displays debugging information for any BPI-related messages that the CMTS sends or
receives.
Note This command is supported only on images that support BPI or BPI+ encryption.
Tip Debugging must be enabled for one or more cable interfaces, using the
before the debug cable bpiatp command displays any output.
Examples The following shows sample output from the debug cable bpiatp command:
Router# debug cable interface c3/0
Router# debug cable bpiatp
CMTS bpi_atp debugging is on
Router#
SID : 1
Status[0] : 1
Key Life[0]: 392 sec
Status[1] : 1
Key Life[1]: 87 sec
Req : 1
Upstream Pri SID : 1
SID : 1
SID : 1
SID : 2002
Status[0] : 1
Key Life[0]: 219 sec
Status[1] : 1
Cisco Broadband Cable Command Reference Guide
5-10
debug cable bpiatp
no debug cable bpiatp
Latest : 2
DES Key[0] : DBF08460BF8073B
DES Key[1] : BEC1CAE02022349
Rply : 1
Even Key : D7C2230BF019D02
Odd Key : BD875702048A401
Latest : 2
DES Key[0] : 237C029E0879190B
DES Key[1] : B8020021FDF1AB5
Modification
This command was introduced.
Current : 1
DES IV[0]
DES IV[1]
Rej : 0 Inv : 0
Even IV : D8F26C81A2F01BC
Odd IV : 198C1AB9255113DC
Current : 1
DES IV[0]
DES IV[1]
Chapter 5 Cisco CMTS Debugging Commands
debug cable interface
: D8F26C81A2F01BC
: 198C1AB9255113DC
: 166B0B6207580457
: 7A10B6E235E196E
command,
OL-1581-08