Cisco SR2016T-NA Reference Manual page 439

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

Cisco CMTS Configuration Commands

If you are using the hccp revertive command on a cable interface, do not also configure the

command. Configuring both commands on the same interface can cause multiple switchovers on the

Using hccp track with hccp revertive

As a general rule, if you are using the

the hccp revertive command without also configuring no keepalive on the cable interface. Configuring

both commands on the same interface, along with keepalives, can cause multiple switchovers on the

If you want to use keepalives along with both the

card track each other and the Protect interfaces on the same card track each other.

the guidelines for using these three commands:

Table 2-16 Possible hccp track and hccp revertive Configurations

(Working I/Fs)

The following example shows cable interface 4/0 on a Protect CMTS in group 2 being configured to

automatically revert to protect status after the Working CMTS peer has returned to active duty:

router(config)# interface cable 4/0

router(config-if)# hccp 2 revertive

Related Commands

hccp reverttime

show hccp interface

command on both the Working and Protect interfaces, so that the Working interfaces on the same

(Protect I/Fs)

Specifies the time that the Working CMTS waits before automatically

switching back to a Working CMTS following system switchover.

Displays information for all cable interfaces on which one or more HCCP

groups and authentication modes have been configured.

Displays group information for a specific cable interface on which one or

more groups and authentication modes have been configured.

command on a cable interface, do not also configure

and hccp revertive commands,use the

hccp revertive

keepalive Configuration

keepalive or no keepalive

no keepalive

keepalive or no keepalive

Cisco Broadband Cable Command Reference Guide

hccp revertive

Broadband cable