Table of Contents
Advertisement
clear cable flap-list
clear cable flap-list
To reset the flap-list table for a specific CM or for all CMs connected to the Cisco CMTS, use the clear
cable flap-list command in privileged EXEC mode.
Syntax Description
mac-addr
all
save-counters
Defaults
Clears the flap-list counters.
Command Modes
Privileged EXEC
Command History
Release
11.3 NA
11.3(7)NA
12.1(5)EC1
12.2(4)BC1
12.2(15)BC2
Usage Guidelines
Cable modems are removed from the flap-list table after the number of days (between 1 and 60) specified
by the cable flap-list aging global configuration command. Use the clear cable flap-list command to
remove individual CMs from the flap-list while retaining flapping activity for other CMs, or to clear the
entire flap-list table.
Examples
The following example shows how to remove all the CMs from the flap-list table:
router# clear cable flap-list all
Cisco Broadband Cable Command Reference Guide
2-368
clear cable flap-list {mac-addr | all} [save-counters]
Modification
This command was introduced.
The save-counters option was supported on the Cisco uBR7200 series
routers.
Support was added for the Cisco uBR7100 series routers.
Support for this command (without the save-counters option) was added for
the Cisco uBR10012 router.
The save-counters option was supported on the Cisco uBR10012 router.
Specifies the 48-bit MAC address (hardware address) of an individual
CM to be cleared from the flap-list table.
Removes all CMs from the flap-list table.
(Optional) Preserves the flap-list counters that are displayed by the
show cable flap-list
command and by using SNMP requests to access
the CISCO-CABLE-SPECTRUM-MIB MIB.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
