Cisco SR2016T-NA Reference Manual page 952

Reference guide
Hide thumbs Also See for SR2016T-NA:
Table of Contents

Advertisement

debug cr10k-rp
Command History
Release
12.2(4)BC1
12.2(11)BC2
12.2(11)BC3
Usage Guidelines
The debug cr10k-rp pkt command enables debugging of the different subsystems that are active on the
PRE1 modules in the Cisco uBR10012 router. You can perform general debugging by giving the
command without any options, or you can limit the debugging output to a specific subsystem by
specifying one of the optional keywords.
In Cisco IOS Release 12.2(11)BC2 and later releases, you can use the conditional option, together with
the debug cable mac-address and debug cable interface commands, to display information about
selected packets. The command will display only those packets that match the specified cable interface
or MAC address options.
Together with the conditional option, you can also optionally specify the peek keyword to create
specifically match only those packets that contain a matching MAC address at the specified location in
the datagram. This can be useful for examining certain types of packets, such as DHCP or ARP packets.
Examples
The following example shows typical output for CLI debugging messages:
Router# debug cr10k-rp cli
CR10K RP debug CLI debugging is on
Failed setting clock for slot 2, subunit 1
SNMP Info download failed for slot 2, subunit 1
Config change command for unknown interface!!!
The following example shows typical output for IPC debugging messages:
Router# debug cr10k-rp ipc
CR10K RP debug IPC debugging is on
plugin_card__c10k_sch_card_event: hwidb=Cable8/1/0 if_num=0 event=6
00:03:14: clc_if_stats_event: If stats from Ca8/1/0
00:03:14: Merge: on Ca8/1/0
00:03:14:
00:03:14:
00:03:14:
00:03:14:
plugin_card__c10k_sch_card_event: hwidb=Cable8/1/1 if_num=1 event=6
00:03:14: clc_if_stats_event: If stats from Ca8/1/1
00:03:14: Merge: on Ca8/1/1plugin_card__c10k_sch_card_event: hwidb=Cable6/0/0 if_num=0
event=6
00:03:15: clc_if_stats_event: If stats from Ca6/0/0
00:03:15:
Merge: on Ca6/0/0
00:03:15:
Cisco Broadband Cable Command Reference Guide
5-92
Modification
This command was introduced for the Cisco uBR10012 universal
broadband router.
The conditional and peek options were added for the pkt keyword.
The ha-all, ha-msg, and ha-timing options were added to support
High-Availability N+1 (1:n) redundancy operations.
Outputs
RP
0
40
SIC
0
0
LC
0
40
Outputs
Chapter 5
Tot_Outs
TotTxBytes
7103
0
7103
Tot_Outs
TotTxBytes
Cisco CMTS Debugging Commands
OL-1581-08

Advertisement

Table of Contents
loading

This manual is also suitable for:

Broadband cable

Table of Contents