Chapter 4
Commands for the Cisco uBR10012 Router
version=1.1.0, description=Release Software created Wed 17-Jul-02 16:58
<<list of interfaces going down or coming up>>
00:49:42: !!pxf clients started, forwarding code operational!!
Router(config)#
The following example shows how to reload the microcode on the PXF processors on the PRE1 module,
using a specific image that is stored in the Flash memory:
Router# configure terminal
Router(config)# microcode pxf flash:pxf/ubr10k-ucode.122.1.2.3
Reload microcode? [confirm] yes
1d04h: Downloading Microcode: file=flash:pxf/ubr10k-ucode.122.1.2.3, version=122.1.2.3,
description=Release Software created Thu 17-Oct-02 11:33
<<list of interfaces going down or coming up>>
1d04h: !!pxf clients started, forwarding code operational!!
Router(config)#
Related Commands
Command
hw-module reset
microcode reload
show pxf microcode
OL-1581-08
Description
Resets a particular PRE1 module or a particular line card.
Reloads the microcode software images on one or all line cards that support
downloadable microcode.
Displays display identifying information for the microcode being used on
the PXF processors.
Cisco Broadband Cable Command Reference Guide
microcode
4-33