Table of Contents
Advertisement
redundancy switch-activity
redundancy switch-activity
To force a switchover to the standby PRE module, use the redundancy switch-activity command in
privileged EXEC mode.
The terms failover and switchover are interchangeable, but switchover is the term used across all
Note
Cisco platforms capable of high-availability operation.
Syntax Description
force
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(4)XF1
Usage Guidelines
The redundancy switch-activity command is similar to the
command, except that it includes an option to force the switchover, overriding any configuration checks
or other checks in the software that could prevent the switchover. In all cases, this command verifies that
the standby PRE module is available and capable of performing the switchover before it transfers control
to that PRE module. This command also synchronizes the current running-config and client data before
initiating the switchover.
Examples
The following example shows a switchover being manually initiated, overriding any checks that might
prevent or delay the switchover:
Router# redundancy switch-activity force
Proceed with switchover to standby PRE? [confirm] y
Pressing enter or y confirms the action and begins the switchover. Pressing any other key aborts the
Note
switchover and returns control to the current active PRE1 module.
Cisco Broadband Cable Command Reference Guide
4-42
redundancy switch-activity [force]
(Optional) Forces a switchover immediately, overriding any checks in the
code or configuration that might prevent or delay a switchover.
Modification
This command was introduced for the Cisco uBR10012 router.
Chapter 4
Commands for the Cisco uBR10012 Router
redundancy force-failover main-cpu
OL-1581-08
Advertisement
Table of Contents
