Cisco SR2016T-NA Reference Manual page 1167

Chapter 6 Cable CPE Commands
show interfaces cable-modem
To display information about the cable interface, use the show interfaces cable-modem command in
privileged EXEC mode.
Cisco uBR904, uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description number
accounting
counters
crb
irb
type
Defaults When this command is entered without a keyword, general information about the cable interface is
displayed.
Command Modes
Privileged EXEC
Command History Release
11.3(4)NA
12.0(4)XI1
12.1(3)XL
12.1(5)XU1
12.2(2)XA
Examples
The following example shows typical output for the cable interface when traffic is passing through the
interface:
Router# show interfaces cable-modem 0
OL-1581-07
show interfaces cable-modem number [accounting | counters | crb | irb | type]
Identifies the cable interface (always 0).
(Optional) Displays the number of packets of each protocol type that has been
sent through the router interface.
(Optional) Shows MIB counters on the cable interface.
(Optional) Displays concurrent routing and bridging information for each
interface that has been configured for routing or bridging. This option does not
really apply to the router but is included because it is part of the subsystem that
provides DOCSIS-compliant bridging. For more information, refer to the
Bridging and IBM Networking Command Reference.
(Optional) Displays integrated routing and bridging information for each
interface that has been configured for routing or bridging. This option does not
really apply to the router but is included because it is part of the subsystem that
provides DOCSIS-compliant bridging. For more information, refer to the
Bridging and IBM Networking Command Reference.
(Optional) Designed to display information about virtual LANs associated with
the interface; however, this option is not supported on the router.
Modification
This command was introduced for the Cisco uBR904 cable access router.
Support was added for the Cisco uBR924 cable access router.
Support was added for the Cisco uBR905 cable access router.
Support was added for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
show interfaces cable-modem
Cisco Broadband Cable Command Reference Guide
6-165