Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
port (dial-peer)
To associate a dial peer with a specific voice port, use the port dial-peer configuration command. To
cancel this association, use the no form of this command.
Cisco uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
For complete details on this command for all supported platforms, see the
Note
Fax Command Reference, Release
Syntax Description:
number
Defaults
No port is configured.
Command Modes
Dial-peer configuration
Command History
Release
11.3(1)T
11.3(3)T
11.3MA
12.0(3)T
12.0(4)T
12.0(7)T
12.1(5)XU1
12.2(2)XA
Usage Guidelines
This command is used for calls incoming from a telephony interface to select an incoming dial peer and
for calls coming from the VoIP network to match a port with the selected outgoing dial peer.
This command applies only to POTS peers.
Note
OL-1581-07
port number
no port number
Specifies one of the RJ-11 voice port connectors installed in the router. Valid
entries are 0 (which corresponds to the RJ-11 connector labeled V1) and 1
(which corresponds to the RJ-11 connector labeled V2).
Modification
This command was introduced (Cisco 3600 series router).
Support was added for the Cisco 2600 router.
Support was added for the Cisco MC3810 multiservice concentrator.
Support was added for the Cisco AS5300 universal access server.
Support was added for the Cisco uBR924 cable access router.
Support was added for the Cisco AS5800 universal gateway.
Support was added for the Cisco CVA122 Cable Voice Adapter.
Support was added for the Cisco uBR925 cable access router.
12.2, available on Cisco.com.
Cisco Broadband Cable Command Reference Guide
port (dial-peer)
Cisco IOS Voice, Video, and
6-65
Advertisement
Table of Contents
