Cisco SR2016T-NA Reference Manual page 394

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

clear cable modem flap-counters

To reset the CM flap-list counters to zero, use the clear cable modem counters command in privileged

Syntax Description

cable slot/port

cable slot/subslot/port

No default behavior or values

Command Modes

Privileged EXEC

Command History

Cisco Broadband Cable Command Reference Guide

clear cable modem {mac-addr | ip-addr | cable slot/port {all | oui string | reject} } flap-counters

clear cable modem {mac-addr | ip-addr | cable slot/subslot/port {all | oui string | reject} } flap-

Modification

This command was introduced, replacing the

Specifies the 48-bit hardware address (MAC address) of an individual

Specifies the IP address of an individual CM.

Identifies the a interface and downstream port on the Cisco uBR7100

series and Cisco uBR7200 series routers.

On the Cisco uBR7100 series router, the only valid value is 1/0. On the

Cisco uBR7200 series router, slot can range from 3 to 6, and port can

be 0 or 1, depending on the cable interface.

Identifies a cable interface on the Cisco uBR10012 router. The

following are the valid values:

slot = 5 to 8

subslot = 0 or 1

port = 0 to 4 (depending on the cable interface)

Resets the flapping counters for all CMs.

Resets the flapping counters for all CMs that match the specified

Organization Unique Identifier (OUI). The string parameter can be

either the three byte hexadecimal string (such as 00.00.0C) or a vendor

name that has been defined using the

Resets the flapping counters for all CMs that are currently in one of the

reject states (see the description of these states in the

Cisco CMTS Configuration Commands

cable modem vendor

clear cable modem counters

Broadband cable