Table of Contents
Advertisement
cpe max
cpe max
To create a DOCSIS configuration file that specifies the maximum number of CPE devices that can use
the CM to connect to the cable network, use the cpe max command in cable config-file configuration
mode. To remove the CPE specification, use the no form of this command.
Syntax Description
cpe-num
Defaults
1 CPE device
Command Modes
Cable config-file configuration
Command History
Release
12.1(2)EC1
12.2(4)BC1
Usage Guidelines
The CM enforces the limitation imposed by the cpe max command, but the CMTS might enforce its own
lower number of CPE devices. On Cisco CMTS routers, a cpe-num value of 0 enables an unlimited
number of hosts, but on some CMs, this value provides only 0 hosts.
Examples
The following example shows how to set the maximum CPE value for the configuration file:
router(config)# cable config-file channeloverride.cm
router(config-file)# cpe max 3
router(config-file)# exit
Related Commands
Command
cable config-file
access-denied
channel-id
download
frequency
option
privacy
service-class
Cisco Broadband Cable Command Reference Guide
2-396
cpe max cpe-num
no cpe max
Specifies the number of CPEs. Valid range is 1 to 254.
Modification
This command was introduced.
Support was added to the Release 12.2 BC train.
Description
Creates a DOCSIS configuration file and enters configuration file
mode.
Disables access to the network.
Specifies upstream channel ID.
Specifies download information for the configuration file.
Specifies downstream frequency.
Provides config-file options.
Specifies privacy options for baseline privacy images.
Specifies service class definitions for the configuration file.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
