Cisco SR2016T-NA Reference Manual page 481

Chapter 2 Cisco CMTS Configuration Commands
privacy
To create a DOCSIS configuration file that enables and configures the DOCSIS Baseline Privacy
Interface (BPI) option, use the privacy command in cable config-file configuration mode. To disable BPI
for the CM, use the no form of this command.
Syntax Description
authorization value
tek value
authorize value
operational value
re-authorize value
reject value
rekey value
Defaults
No default behaviors or values
Command Modes Cable config-file configuration
Command History Release
12.1(2)EC1
12.2(11)BC2
Usage Guidelines Specifying the privacy command without any of the keywords and arguments enables BPI encryption
and decryption for the CM. In addition to this command, you must also specify the
command to enable BPI operations on the cable modem.
OL-1581-08
privacy grace-time {authorization value | tek value}
privacy timeout {authorize value| operational value| re-authorize value| reject value| rekey
value}
no privacy grace-time {authorization | tek}
no privacy timeout {authorize | operate | re-authorize | reject | rekey}
Authorization grace time in seconds. Valid values are 1 to 1800 seconds.
Default value is 600 seconds.
TEK grace time in seconds. Valid range is 1 to 1800 seconds. Default is 600
seconds.
Authorize wait timeout in seconds. Valid range is 1 to 30 seconds. Default
value is 10 seconds.
Operational Wait timeout in seconds. Valid range is 1 to 10 seconds. Default
is 1 second.
Re-authorize wait timeout in seconds. Valid range is 1 to 20 seconds.
Authorize reject wait timeout in seconds. Valid range is 1 to 600 seconds.
Default is 60 seconds.
Rekey wait timeout in seconds. Valid range is 1 to 10 seconds. Default is 1
second.
Modification
This command was introduced.
This command was supported on the Release 12.2 BC train.
Cisco Broadband Cable Command Reference Guide
privacy
service-class privacy
2-469