Table of Contents
Advertisement
debug cable subscriber-monitoring
debug cable subscriber-monitoring
To display debugging messages the use of the
quality of service (QoS) profile, use the debug cable subscriber-monitoring command in privileged
EXEC mode. To stop the display of debugging messages, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
Because this command can produce a large volume of debug information, use this command only when
Tip
you have also enabled debugging for a particular interface or MAC address, using the debug cable
interface and debug cable mac-address commands, respectively.
Examples
The following example shows how to enable debugging output using the debug cable
subscriber-monitoring command:
Router# debug cable subscriber-monitoring
subscriber monitoring debugging is on
cmts_enf_map_sm_to_qos: enforced=9, penalty_life_time=10080
cmts_enf_map_sm_to_qos: Found rule #=9, rule_name=name, dir=US
cmts_enf_map_sm_to_registered_qos1: us smp=0x00, ds smp=0x1F
Related Commands
Command
cable qos enforce-rule
debug cable interface
Cisco Broadband Cable Command Reference Guide
5-74
debug cable subscriber-monitoring
no debug cable subscriber-monitoring
Modification
This command was introduced.
Description
Creates an enforce-rule to be used to enforce a particular quality of service
(QoS) profile and enters enforce-rule configuration mode.
Enables debugging output for a specific cable interface.
Chapter 5
cable qos enforce-rule
command to enforce a particular
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
