Table of Contents
Advertisement
Chapter 6
Cable CPE Commands
debug cable-modem map
To display the timing of MAP messages to sync messages, and the timing between MAP messages, use
the debug cable-modem map command in privileged EXEC mode. To turn off debugging of MAP
messages, use the no form of this command.
Cisco uBR904, uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Release
11.3(4)NA
12.0(4)XI1
12.0(5), 12.0(5)T
Usage Guidelines
In Cisco IOS Release 12.0(5) and later releases, this command is available only under the direction of
TAC or field service, and should be used only while debugging CM operation. Displaying debugging
messages consumes system resources, and turning on too many messages could negatively affect system
performance.
Examples
The following shows typical output from the debug cable map command:
Router# debug cable-modem map
Cable Modem MAP debugging is on
Router#
*Mar
*Mar
*Mar
*Mar
*Mar
*Mar
*Mar
Related Commands
Command
debug cable-modem bpkm
debug cable-modem bridge
debug cable-modem error
OL-1581-07
debug cable-modem map
no debug cable-modem map
Modification
This command was introduced for the Cisco uBR904 cable access router.
Support was added for the Cisco uBR924 cable access router.
This command was removed from normal access.
7 20:12:08: 595322.942: Min MAP to sync=72
7 20:12:08: 595322.944: Max map to map time is 40
7 20:12:08: 595322.982: Min MAP to sync=63
7 20:12:08: 595323.110: Max map to map time is 41
7 20:12:08: 595323.262: Min MAP to sync=59
7 20:12:08: 595323.440: Max map to map time is 46
7 20:12:09: 595323.872: Min MAP to sync=58
Description
Displays information about Baseline Privacy Interface (BPI) key
management.
Displays bridge filter processing information.
Displays debugging messages for the cable interface driver.
Cisco Broadband Cable Command Reference Guide
debug cable-modem map
6-203
Advertisement
Table of Contents
