Cisco SR2016T-NA Reference Manual page 846

show pxf microcode
Router#
Table 4-13
Table 4-13 Field Descriptions for the show pxf microcode Command
Field
PXF complex
Loaded microcode
Version
Release Software
created
Microcode load
attempted
DISABLE_BOOTSTR
AP
tmc0, tmc1
Cobalt registers
Related Commands Command
clear pxf
debug pxf
microcode
microcode reload
show pxf cable
show pxf cable
interface
show pxf cpu
Cisco Broadband Cable Command Reference Guide
4-86
000000A0 000001C0 00000040
000000B0 00000200 00000200
000000B0 00000100 00000000
000000B0 0000003F 00000010
describes the fields shown in the show pxf microcode command:
Description
Describes the number of PXF (Toaster) processors, their associate memory
columns, and their current status.
Describes the source and filename for the microcode that is currently loaded
on the PXF processor.
Identifies the major and minor version numbers for the current release of
microcode.
Identifies the time and date the current microcode was compiled.
Identifies the number of times the PXF processor has loaded the microcode
since the Cisco IOS image was loaded at system bootup. Also shows the time
(in days and hours) since the last successful load of the microcode.
Displays the current state of operation for the PXF processor. During normal
operation, this line shows "DISABLE_BOOTSTRAP_CLEAR".
Identifies the current program counters and configuration for the two PXF
processors.
Provides a hexadecimal dump of the current contents of the register for the
Cobalt support chip, which manages the interface between the PXF
processors and the backplane, and which also manages the memory for the
packet buffers.
Description
Clears the direct memory access (DMA) and error checking and correcting
(ECC) error counters on the PXF processor.
Enables debugging of the PXF subsystems on the active PRE1 module on
the Cisco uBR10012 router.
Reloads the microcode software images on one or all line cards that support
downloadable microcode.
Reloads the microcode software images on one or all line cards that support
downloadable microcode.
Displays information about the multicast echo and packet intercept features
for one or all cable interfaces.
Displays information about a particular service ID (SID) on a particular
cable interface.
Displays the display different statistics about the operation of the CPU
processor during PXF processing.
Chapter 4 Commands for the Cisco uBR10012 Router
OL-1581-08