Table of Contents
Advertisement
cable-modem voip best-effort
cable-modem voip best-effort
To allow voice calls to be sent upstream over the cable interface using best-effort quality of service
(QoS), use the cable-modem voip best-effort command in cable interface configuration mode. To
disable best-effort voice calls, use the no form of this command.
Cisco uBR924 cable access router
Cisco IOS Release 12.1(2)T removed this command from the CLI for all platforms and reserved it for
Note
exclusive use by the DOCSIS provisioning process.
Syntax Description
This command has no arguments or keywords.
Defaults
Enabled
Command Modes
Interface configuration (cable interface only)
Command History
Release
11.3(4)NA
12.0(4)XI1
12.1(2)T
Usage Guidelines
This command allows you to configure the voice traffic on a router to allow only calls having a
high-priority service identifier (SID) to be connected.
If the dynamic configuration of high-priority queues for voice traffic fails, or if the far end cannot
support the multiple SIDs and multiple classes of service required by high-priority traffic, the flag set
by this command will be checked. If enabled (the default setting), the call will be allowed to go through.
If disabled, the call will fail.
Examples
The following example shows how to disable best-effort voice calls:
Router(config)# interface cable-modem 0
Router(config-if)# no cable-modem voip best-effort
Router(config-if)#
Cisco Broadband Cable Command Reference Guide
6-18
cable-modem voip best-effort
no cable-modem voip best-effort
Modification
This command was introduced for the Cisco uBR904 cable access router.
Support was added for the Cisco uBR924 cable access router.
This command was removed from the CLI for all platforms and reserved for
exclusive use by the DOCSIS provisioning process.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
