Table of Contents
Advertisement
cable-modem downstream saved channel
To comply with DOCSIS requirements, Cisco IOS Release 12.1(2)T removed this command from the
CLI for all platforms and reserved it for exclusive use by the DOCSIS provisioning process. This
command exists in earlier Cisco IOS versions, but Cisco recommends that this command NOT be used
by end users of Cisco cable CPE devices.
Examples
The following example shows how to remove the downstream frequency of 91,000,000 Hz and the
upstream power level of 33 dBmV from the running configuration of a cable-modem interface:
Router(config)# interface cable-modem 0
Router(config-if)# no cable-modem downstream saved channel 91000000 33
Router(config-if)#
Related Commands
Command
cable-modem compliant bridge
cable-modem fast-search
cable-modem upstream
preamble qpsk
cable-modem voip best-effort
Cisco Broadband Cable Command Reference Guide
6-12
Description
Enables DOCSIS-compliant transparent bridging for the cable
interface at startup.
Enables a faster downstream search algorithm on the cable
interface.
Enables the QPSK modulation scheme in the upstream direction
from the CM interface to the CMTS.
Allows voice calls to be sent upstream over the cable interface via
best effort.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
