Table of Contents
Advertisement
show crypto engine connections
Table 6-23 show crypto engine connections active Field Description
Field
ID
Interface
IP-Address
State
Algorithm
Encrypt
Decrypt
The following example shows typical output from the show crypto engine connections dh command:
Router# show crypto engine connections dh
Conn
0
0
0
0
0
Router#
Table 6-24
Table 6-24 show crypto engine connections dh Field Description
Field
Conn
ID
Status
The following example shows typical output from the show crypto engine connections
dropped-packet command:
Router# show crypto engine connections dropped-packet
Cisco Broadband Cable Command Reference Guide
6-156
ID
Status
0
1
14
1
0
1
0
1
18
1
describes the fields shown in the display.
Description
Identifies the connection by its number. Each active encrypted
session connection is identified by a positive number from 1 to
299. These connection numbers correspond to the table entry
numbers.
Interface involved in the encrypted session connection.
IP address of the interface.
Current state of the connection:
alloc—the connection is requesting resources.
•
•
set—an active connection (normal state).
The encryption algorithms used for this connection. If this field
reads "NONE," this connection is still being allocated and has
not yet requested an algorithm.
Total number of encrypted outbound IP packets.
Total number of encrypted outbound IP packets.
Description
Identifies the connection by its number. Each active encrypted
session connection is identified by a positive number from 1 to
299. These connection numbers correspond to the table entry
numbers.
Identifies the Diffie-Hellman group.
Identifies the Diffie-Hellman status:
1—768-bit Diffie-Hellman prime modulus group.
2—1024-bit Diffie-Hellman prime modulus group.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
