Table of Contents
Advertisement
cable-modem dhcp-proxy
Usage Guidelines
This command is useful in three situations:
•
•
•
After configuring the router with the cable-modem dhcp-proxy command, reboot the router. During the
DOCSIS provisioning process, the router sends a DHCP client request to obtain an IP address for the
cable interface.
The router then sends a proxy DHCP request to the DHCP server using the Ethernet interface's MAC
address. The DHCP server replies with a second IP address that the router assigns to either the Ethernet
or loopback interface, or to the NAT pool, depending on which option was used in the cable-modem
dhcp-proxy command.
When replying to the proxy request for the Ethernet interface, the DHCP server should assign an IP
Note
address that is on the same network as the customer premises equipment (CPE) devices that are attached
to the router's Ethernet interface.
If you have configured a Cisco CM for routing mode and are also using the cable-modem dhcp-proxy
Tip
nat command on the CM, you must configure the corresponding cable interface on the Cisco CMTS with
the cable dhcp-giaddr policy command.
Using NAT and DHCP Proxy and Copying Configuration Files
Most service providers typically create a standard configuration file for their cable modems, verify it,
and then copy the working configuration as needed to other cable modems. This can cause problems
when using the cable-modem dhcp-proxy command to create a NAT address pool for NAT/PAT
translation.
Cisco Broadband Cable Command Reference Guide
6-8
When the router is configured for routing mode, an IP address must be assigned to its Ethernet
interface. Without the cable-modem dhcp-proxy command, this IP address must be a static IP
address assigned either by using a Cisco IOS configuration file or by manually entering the
necessary interface configuration CLI commands. The cable-modem dhcp-proxy command allows
a DHCP server to assign an IP address to the Ethernet interface.
When NAT is used, an inside global address pool must be created on the Ethernet interface. Without
the cable-modem dhcp-proxy command, this must be done by specifying a static IP address in the
ip nat pool pool-name start-ip end-ip netmask subnet command. The cable-modem dhcp-proxy
command allows a DHCP server to assign an IP address that automatically creates the NAT address
pool.
When using this option, you must also use the following NAT configuration commands:
Use the ip nat inside command in interface configuration mode to configure the Ethernet
–
interface as the inside interface.
–
Use the ip nat outside command in interface configuration mode to configure the cable
interface as the outside interface.
Specify the overload option with the ip nat command in global configuration mode to
–
implement Port Address Translation (PAT) so that multiple PCs can use the single IP address in
the NAT pool created by the cable-modem dhcp-proxy command.
When using the Cisco Easy VPN feature to create a VPN tunnel, the command allows a static
address to be used for the tunnel's creation.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
