Table of Contents
Advertisement
debug cable us-adm-ctrl
debug cable us-adm-ctrl
To enable debugging of upstream admission control activity, use the debug cable us-adm-ctrl command
in privileged EXEC mode. To disable debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Release
12.1(4)CX
12.2(4)BC1
12.2(11)CY
Examples
The following command shows how to enable debugging output for upstream admission control:
Router# debug cable us-adm-ctrl
CMTS upstream admission control debugging is on
Router# show debug
CMTS:
CMTS upstream admission control debugging is on
Router#
The following are the debug messages that are displayed when the CMTS does not have an admission
policy, scheduling instance, or service class for a registering CM:
Null service class
Null admission policy
Null scheduler instance
The CMTS displays the following debug message when a CM requests a scheduling type that is either
not defined, not recognized, or not supported:
Undefined scheduling Type
Cisco Broadband Cable Command Reference Guide
5-88
debug cable us-adm-ctrl
no debug cable us-adm-ctrl
Modification
This command was introduced for the Cisco uBR10012 router.
Support for this command was added to the Release 12.2 BC train for
the Cisco uBR7100 series, Cisco uBR7200 series, and
Cisco uBR10012 routers.
Support was added for the Cisco uBR10-MC5X20S cable interface
line card on the Cisco uBR10012 router.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
