Cisco SR2016T-NA Reference Manual page 845

Chapter 4 Commands for the Cisco uBR10012 Router
show pxf microcode
To display identifying information for the microcode being used on the Parallel eXpress Forwarding
(PXF) processor, use the show pxf microcode command in user EXEC or privileged EXEC mode.
Syntax Description
This command has no keywords or arguments.
Defaults No default behavior or values
Command Modes
User EXEC, Privileged EXEC
Command History Release
12.2(4)XF1
12.2(15)BC2
Usage Guidelines
The PXF processors onboard the Performance Routing Engine (PRE1) module automatically load their
microcode at the same time that the Cisco IOS image is loaded into the PRE1 module. A fault situation
can cause one or both of the PXF processors to reload the microcode as needed. You can use the show
pxf microcode command to display the version of microcode currently loaded, as well as the number of
times the microcode has been loaded since the Cisco IOS software was loaded at system bootup.
Examples The following example shows a typical display for the show pxf microcode command:
Router# show pxf microcode
PXF complex: 2 Toasters 8 Columns total
Toaster processor tmc0 is running.
Toaster processor tmc1 is running.
Loaded microcode: system:pxf/u10k-1-ucode.2.3.1
OL-1581-08
show pxf microcode
Modification
This command was introduced as show hardware pxf microcode for the
Cisco uBR10012 router.
This command was renamed from show hardware pxf microcode to show
pxf microcode.
Version: 2.3.1
Release Software created Wed 04-Sep-02 10:04
Signature: c99db74b91f8fae0a15e62e152c3f49f
Microcode load attempted 1 time(s), latest 3d17h ago
DISABLE_BOOTSTRAP_CLEAR
tmc0 FG_PC=1 BG_PC=5 WDog=1024 MinPhase=31
tmc1 FG_PC=1 BG_PC=5 WDog=1024 MinPhase=31
Cobalt Registers: 9 registers specified
00000064 0000000F 00000001
00000090 FFFF0000 FF000000
00000090 000003C0 00000000
00000090 00000003 00000002
00000094 FFFFFFFF AAAAAAAA
Cisco Broadband Cable Command Reference Guide
show pxf microcode
4-85