Cisco SR2016T-NA Reference Manual page 438

Reference guide

Hide thumbs Also See for SR2016T-NA:

Table of Contents

hccp revertive

To configure a cable interface on a Protect CMTS that has assumed working capacity to automatically

revert back to the Working CMTS, use the hccp revertive command in cable interface configuration

mode. To disable the ability for the specified cable interface to automatically revert back to protect

status, use the no form of this command.

Syntax Description

This command is disabled by default because some customers may want to perform testing or other such

activity on the Protect CMTS working peer before restoring it to working status.

Command Modes

Interface configuration (cable interface only)

Command History

Usage Guidelines

Using this command in conjunction with the

your protecting cable interfaces to automatically switch between working and protecting capacity

without your intervention. Otherwise, whenever a switchover has occurred, you must manually

reactivate the failed Working CMTS and manually return the Protect CMTS to protect status using the

Cisco Broadband Cable Command Reference Guide

hccp group revertive

no hccp group revertive

The group number for the specified interface. Valid values are any number

from 1 to 255, inclusive.

Modification

This command was introduced for the Cisco uBR7200 series routers.

Support was added for the Cisco uBR-MC16S cable interface line card.

Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012

router and Cisco uBR-LCP-MC28C card.

Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012

router and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and

Cisco uBR-LCP-MC16S cards.

Support was added for the N+1 (1:n) RF Switch with the

Cisco uBR7246VXR router and Cisco uBR-MC16C, Cisco uBR-MC16S,

and Cisco uBR-MC28C cards.

hccp reverttime

command gives you the ability to set up

Cisco CMTS Configuration Commands

Broadband cable