Table of Contents
Advertisement
registered qos-profile
The following example shows the error message that is displayed when the specified QoS profile does
not exist on the CMTS:
Router# configure terminal
Router(config)# cable qos enforce-rule test
Router(enforce-rule)# registered qos-profile 99
The qos profile 99 doesn't exist or it's a cm created QoS profile
Router(enforce-rule)#
Related Commands
Command
activate-rule at-byte-
count
cable qos enforce-rule
enabled
enforced qos-profile
monitoring-duration
penalty-period
show cable qos
enforce-rule
show cable
subscriber-usage
Cisco Broadband Cable Command Reference Guide
2-472
Description
Specifies the number of bytes that a subscriber can transmit during the
monitoring period.
Creates an enforce-rule to be used to enforce a particular quality of service
(QoS) profile and enters enforce-rule configuration mode.
Activates an enforce-rule and begins subscriber traffic management.
Specifies the quality of service (QoS) profile that should be enforced when
users violate their assigned QoS profiles.
Specifies the time period and sample rate to be used for monitoring
subscribers.
Specifies the time period that an enforced quality of service (QoS) profile
should be used for subscribers that violate their registered QoS profile.
Displays the quality of service (QoS) enforce-rules that are currently
defined.
Displays subscribers that are violating their registered quality of service
(QoS) profiles.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
