Cisco SR2016T-NA Reference Manual page 569

Chapter 3 Cisco CMTS Show Commands
show cable modem connectivity
To display connectivity statistics for one or more CMs, use the show cable modem connectivity
command in privileged EXEC mode.
Syntax Description
ip-address
mac-address
cable slot/port
cable slot/subslot/port
upstream port
rate [threshold]
Command Modes Privileged EXEC
Command History Release
12.1(4)CX and
12.2(4)BC1
12.3(9a)BC
OL-1581-08
show cable modem [ip-address | mac-address] connectivity [rate [threshold] ]
show cable modem cable slot/port [upstream port] connectivity [rate [threshold] ]
show cable modem cable slot/subslot/port [upstream port] connectivity [rate [threshold] ]
(Optional) Displays information for the specific CM with the specified IP
address.
(Optional) Displays information for the specific CM with the specified
MAC address.
(Optional) Displays information for all CMs on the specified cable interface
and downstream port on the Cisco uBR7100 series and Cisco uBR7200
series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
(Optional) Displays information for all CMs on the specified cable interface
on the Cisco uBR10012 router. The following are the valid values:
•
•
•
(Optional) Displays information for all CMs using this specific upstream.
You can specify this option only when displaying information for a cable
interface. The valid range for port begins with 0 and ends with a value that
depends on the number of upstream ports on the cable interface line card.
(Optional) Displays a graphical representation of the connect rates for CMs.
•
Modification
This command was introduced (and the connectivity option was removed
from the
Support was added for the rate option.
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
threshold—(Optional) Specifies that the graphical display should show
only those time periods when this number of CMs, or more, came
online. The valid range is 2 to 20, with no default (the graph shows
when each CM came online).
show interface cable sid
Cisco Broadband Cable Command Reference Guide
show cable modem connectivity
command).
3-73