Table of Contents
Advertisement
Chapter 5
Cisco CMTS Debugging Commands
debug cr10k-rp
To enable debugging of the subsystems on the active Performance Routing Engine (PRE1) module on
the Cisco uBR10012 router, use the debug cr10k-rp pkt command in privileged EXEC mode. To disable
debugging output, use the no form of the command.
Syntax Description
cli
drv
ha-all
ha-error
ha-msg
ha-recovery
ha-timing
ipc
oir
pkt
conditional
peek byte
sid
spec
Command Modes
Privileged EXEC
OL-1581-08
debug cr10k-rp [cli | drv | ha-all | ha-error | ha-msg | ha-recovery | ha-timing | ipc | oir | pkt
[conditional [peek byte] ] | sid | spec]
no debug cr10k-rp [cli | drv | ha-all | ha-error | ha-msg | ha-recovery | ha-timing | ipc | oir | pkt
[conditional [peek byte] ] | sid | spec]
(Optional) Displays debugging messages for the command-line interface
(CLI) commands run on the processor.
(Optional) Displays debugging messages for the processor's driver software.
(Optional) Displays debugging messages related to High Availability (HA)
redundancy events.
(Optional) Displays debugging messages about errors related to the recovery
of cable modems during HA switchovers.
(Optional) Displays debugging messages for HA bulk synchronization
operations.
(Optional) Displays debugging messages related to the recovery operations
for cable modems after HA switchovers. In particular, these messages
concern the recovery of high-priority cable modems that have voice calls.
(Optional) Displays debugging messages related to HA timing events.
(Optional) Displays debugging messages for the processor's interprocess
communications (IPC) system.
(Optional) Displays debugging messages for online insertion and removal
(OIR) operations.
(Optional) Displays debugging messages for the packets that the PRE1
module processes.
(Optional) Enables conditional debugging for the packets processed by the
PRE1 module.
(Optional) Specifies that debugging should show the value for a specific byte
in each packet processed by the PRE. The valid range for byte is 1 to 120.
(Optional) Displays debugging messages for the service IDs (SIDs)
processed by the PRE1 module.
(Optional) Displays debugging messages for spectrum management
operations.
Cisco Broadband Cable Command Reference Guide
debug cr10k-rp
5-91
Advertisement
Table of Contents
