Cisco SR2016T-NA Reference Manual page 426

hccp channel-switch
console
vty
line-number
port
wavecom-hd
wavecom-ma
prot-ip-address
protect-module
work-ip-address
work-module
Defaults The CMTS is not configured to use a Cisco RF Switch by default, and no cable interfaces are configured
for N+1 redundancy by default.
Command Modes
Interface configuration (cable interface only)
Command History Release
12.2(4)XF1,
12.2(4)BC1
12.2(8)BC2
12.2(11)BC1
Usage Guidelines
You must configure each Working and Protect cable interface for use with the Cisco RF Switch, typically
specifying one hccp channel-switch command to configure the Cisco RF Switch information, and
another hccp channel-switch command to configure the upconverter.
The Protect interface is configured with the same hccp channel-switch commands as those that are used
on the Working interface. However, typically, the same Protect interface is configured with multiple
hccp channel-switch commands to protect multiple Working interfaces.
Cisco Broadband Cable Command Reference Guide
2-414
(Optional) Specifies that the console port is being used to control the
Cisco RF Switch.
(Optional) Specifies that a Virtual Terminal connection (Telnet connection)
is being used to control the Cisco RF Switch.
Specifies the line number on which the Cisco RF Switch is receiving control
information for this CMTS. The valid range is 0 to 17 for the default serial
port, 0 for the aux port, 0 for the console port, and 0 to 99 for the vty port.
Specifies the port number being used on the Cisco RF Switch. The valid
range is 1 to 255.
Specifies that this is the configuration for a VCom (Wavecom) HD4040 and
QHD4040 upconverter.
Specifies that this is the configuration for a VCom (Wavecom)
DUAL4040D, MA4040D, or UC4040D upconverter.
Specifies the IP address for the upconverter used for the Protect interface
used for this cable interface.
Specifies the module number on the upconverter used for the Protect
interface to be used for this cable interface. The valid range is 1 to 255.
Specifies the IP address for the upconverter used for the Working interface
used for this cable interface.
Specifies the module number on the upconverter used for the Working
interface to be used for this cable interface. The valid range is 1 to 255.
Modification
This command was introduced for the Cisco uBR10012 router, replacing
the hccp ds-switch command for use with the Cisco RF Switch.
Support was added for the Cisco uBR-LCP-MC16C, Cisco uBR-LCP-
MC16E, and Cisco uBR-LCP-MC16S cards on the Cisco uBR10012 router.
Support was added for the Cisco uBR7246VXR router and
Cisco uBR-MC16C, Cisco uBR-MC16S, and Cisco uBR-MC28C cards.
Chapter 2 Cisco CMTS Configuration Commands
OL-1581-08