Table of Contents
Advertisement
debug cable rfmib
debug cable rfmib
To display debugging messages about when the DOCSIS-IF-MIB MIB is updated, use the debug cable
rfmib command in privileged EXEC mode. To disable debugging output, use the no form of this
command.
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Release
12.2(15)BC1
Usage Guidelines
This command displays debugging messages when the counters in the DOCSIS-IF-MIB are updated.
For more information about the information displayed by this command, see
Note
DOCS-IF-MIB MIB at the following URL:
http://www.cisco.com/go/mibs
Examples
The following shows typical output from the debug cable rfmib command:
Router# debug cable rfmib
CMTS RFMIB debugging is on
Router#
CMTS is calculating utilization.
Calculating all utilization data.
Polling and calculating all channels utilization data.
Polling and calculating all channels utilization data.
Cable7/0/0 DS
cur_snmp_ifOutOctets 29282580
cur_snmp_total_bytes 3348841605
last_snmp_ifOutOctets 27327636
last_snmp_total_bytes 3126121018
Cable7/0/0 DS, delta_outoctets 1954944, delta_total_bytes 222720587, chan_utilization 1
Cable7/0/0 US 2
cur_snmp_total_ms 36065552
cur_snmp_ucast_grnt_ms 11287
Cisco Broadband Cable Command Reference Guide
5-70
debug cable rfmib
no debug cable rfmib
Modification
This command was introduced.
Chapter 5
Cisco CMTS Debugging Commands
RFC 2670
and the
OL-1581-08
Advertisement
Table of Contents
