Table of Contents
Advertisement
Chapter 4
Commands for the Cisco uBR10012 Router
Router#
Table 4-10
Table 4-10 Field Descriptions for the show pxf cpu schedule Command
Field
Interface
Level 1
Level 2
maximum
1 min
5 min
60 min
Statistics
The following example shows a typical display for the statistics diversion option, which shows
chassis-wide statistics for PXF diversions, which occur whenever the PXF processor sends a packet to
the main route processor for special processing (such as errored packets, address resolution protocol
(ARP) packets, point-to-point protocol (PPP) control packets, an unsupported Layer 2 packet header, and
so forth).
Router#
Diversion Cause Stats:
local
dest
option
protocol
encap
oam f5 seg= 0
oam f5 ete= 0
oam f4 seg= 0
oam f4 ete= 0
atm ilmi
fr_term
comp
ip_sanity = 0
ip_bcast
ip_dest
fib_punt
mtu
arp
rarp
icmp
dsap_ssap = 0
acl
divert
no_group
direct
local_mem = 0
p2p_prune = 0
assert
dat_prune = 0
OL-1581-08
describes the fields shown in the show pxf cpu schedule command:
Description
Identifies the cable interface or subinterface.
Displays the number of occupied level 1 (port) wheel slots and the total
number of wheel slots for this interface or subinterface.
Displays the number of occupied level 2 (channel) wheel slots and the total
number of wheel slots for this interface or subinterface.
Displays the maximum number of packet dequeues per second.
Displays the dequeue rate for the last 1-minute period.
Displays the dequeue rate for the last 5-minute period.
Displays the dequeue rate for the last 60-minute period.
show pxf cpu statistics diversion
= 263171
= 0
= 0
= 0
= 541943
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 127
= 0
= 0
= 0
= 0
= 0
= 0
= 0
Cisco Broadband Cable Command Reference Guide
show pxf cpu
4-71
Advertisement
Table of Contents
