Table of Contents
Advertisement
Chapter 3
Cisco CMTS Show Commands
show diag
To display the revision-level information for a Cisco CMTS cable interface, use the show diag command
in privileged EXEC mode.
Syntax Description
slot
Command Modes
Privileged EXEC
Command History
Release
11.1 CA
11.2 P
11.3 XA
12.0(5)XQ
12.1(1a)T1
Usage Guidelines
This command displays information for the electrically erasable programmable read-only memory
(EEPROM), the motherboard, and the WAN interface cards (WICs) and voice interface cards
(VICs).This command also displays information about the cable clock card, if installed.
Examples
The following is sample output from the show diag command displaying diagnostic information for the
cable clock card:
router# show diag
Clockcard:
OL-1581-08
show diag [slot]
Modification
This command was introduced.
This command was modified to update the sample display for the port
adapters PA-12E/2FE, PA-E3, and PA-T3.
This command was made available for Cisco IOS Release 11.3 XA.
This command was enhanced and made available for the Cisco 1750 router.
This command was modified to include information about the cable clock
card.
National clock card with T1 controller
EEPROM contents at hardware discovery:
Hardware Revision
Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
RMA Test History
RMA Number
RMA History
EEPROM format version 4
EEPROM contents (hex):
0x00:04 FF 40 01 AC 41 01 01 C0 46 03 20 00 16 EB 02
0x10:42 31 31 80 00 00 00 00 02 02 C1 8B 43 41 42 30
0x20:34 30 34 36 4E 58 56 03 00 81 00 00 00 00 04 00
(Optional) Identifies the Cisco CMTS chassis slot number to be
displayed.
:1.1
:800-05867-02
:11
:0-0
:02
:CAB04046NXV
:00
:0-0-0-0
:00
Cisco Broadband Cable Command Reference Guide
show diag
3-189
Advertisement
Table of Contents
