Table of Contents
Advertisement
secondary aux
secondary aux
To enable the auxiliary port on the standby PRE1 module, use the secondary aux command in
redundancy configuration (main-cpu) mode. To disable the auxiliary port, use the no form of this
command.
Syntax Description
This command has no keywords or arguments.
Defaults
The auxiliary port on the standby PRE1 module is disabled.
Command Modes
Redundancy configuration, main-cpu mode
Command History
Release
12.2(11)BC3
Examples
The following example shows how to enable the auxiliary port on the standby PRE1 module.
Router# config t
Router(config)# redundancy
Router(config-r)# main-cpu
Router(config-r-mc)# secondary aux
Router(config-r-mc)# exit
Router(config-f)# exit
Router(config)#
Related Commands
Command
main-cpu
redundancy
redundancy
force-failover
main-cpu
Cisco Broadband Cable Command Reference Guide
4-44
secondary aux
no secondary aux
Modification
This command was introduced for the Cisco uBR10012 router.
Description
Enters main-CPU redundancy configuration mode, so that you can
configure the synchronization of the active and standby Performance
Routing Engine (PRE1) modules.
Configures the synchronization of system files between the active and
standby PRE1 modules.
Forces a manual switchover between the active and standby PRE1 modules.
Chapter 4
Commands for the Cisco uBR10012 Router
OL-1581-08
Advertisement
Table of Contents
