Table of Contents
Advertisement
Chapter 3
Cisco CMTS Show Commands
show cable modem cpe
To display the CPE devices accessing the cable interface through a particular CM, use the show cable
modem cpe command in privileged EXEC mode.
Syntax Description
ip-address
mac-address
Command Modes
Privileged EXEC
Command History
Release
11.3XA
12.1(4)CX and
12.2(4)BC1
Usage Guidelines
This command lists the CPE devices that are accessing the cable network through a particular CM. You
can identify the CM either by its IP address or by its MAC address.
Also see the information about this command's behavior in a Hot Standby Connection-to-Connection
Note
Protocol (HCCP) configuration, see the
Protocol (HCCP) Configuration" section on page
Examples
The following example shows sample output for the show cable modem cpe command, listing the CPE
devices by their MAC and IP addresses:
Router# show cable modem 10.14.1.20 cpe
IP address
10.14.30.100
10.14.30.101
Router#
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
Tip
show commands using the exec prompt timestamp command in line configuration mode.
OL-1581-08
show cable modem {ip-address | mac-address} cpe
Displays the CPE devices for the CM with the specified IP address.
Displays the CPE devices for the CM with the specified MAC address.
Modification
This command was introduced.
The command was simplified to display only the IP and MAC addresses for
the CPE devices.
MAC address
00b0.4a9b.bc8c
00b0.4a9b.bc8d
"Operation with Hot Standby Connection-to-Connection
3-54.
Cisco Broadband Cable Command Reference Guide
show cable modem cpe
3-81
Advertisement
Table of Contents
