Cisco SR2016T-NA Reference Manual page 858

switchover timeout
switchover timeout
To configure the switchover timeout period of the PRE1 module, use the switchover timeout command
in redundancy configuration (main-cpu) mode. To reset the timeout period to its default value, use the
no form of this command.
Syntax Description timeout-period
Defaults 0
Command Modes
Redundancy configuration, main-cpu mode
Command History Release
12.2(11)BC3
Usage Guidelines The switchover timeout command specifies how long the standby PRE module should wait when it does
not detect a heartbeat from the active PRE module before initiating a switchover and assuming
responsibility as the active PRE module. If set to 0, the standby PRE module initiates a switchover
immediately when the active PRE module misses a scheduled heartbeat.
Examples
The following example shows how to set the timeout period to 60 milliseconds:
Router# config t
Router(config)# redundancy
Router(config-r)# main-cpu
Router(config-r-mc)# switchover timeout 60
Router(config-r-mc)# exit
Router(config-f)# exit
Router(config)#
Related Commands Command
main-cpu
Cisco Broadband Cable Command Reference Guide
4-98
switchover timeout timeout-period
no switchover timeout
Specifies the timeout, in milliseconds. The valid range is 0 to 25000
milliseconds (25 seconds), where 0 specifies no timeout period.
Modification
This command was introduced for the Cisco uBR10012 router.
Description
Enters main-CPU redundancy configuration mode, so that you can
configure the synchronization of the active and standby Performance
Routing Engine (PRE1) modules.
Chapter 4 Commands for the Cisco uBR10012 Router
OL-1581-08