Table of Contents
Advertisement
show controllers cable-modem tuner
Table 6-19 show controllers cable-modem tuner Field Descriptions (continued)
Field
power_level
symbol_rate
Tip
In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the
exec prompt timestamp command in line configuration mode.
Related Commands
Command
show controllers cable-modem
show controllers cable-modem
bpkm
show controllers cable-modem
crypto des
show controllers cable-modem
filters
show controllers cable-modem
lookup-table
show controllers cable-modem
mac
show controllers cable-modem
phy
Cisco Broadband Cable Command Reference Guide
6-136
Description
Transmit power level as set in the hardware, given as a hexadecimal value. The
units are unique to the hardware used. Use the show controllers cable-modem
mac state command to see the power level in dBmV.
Indicates the upstream symbol rate in symbols per second that is negotiated
between the CMTS and the cable access router.
Description
Displays high-level controller information about the cable interface.
Displays information about the baseline privacy key management
exchange between the cable interface and the CMTS.
Displays information about the Data Encryption Standard (DES)
engine registers.
Displays the registers in the MAC hardware that are used for
filtering received frames.
Displays the mini-slot lookup table inside the cable interface.
Displays detailed MAC-layer information for the cable interface.
Displays the contents of the registers used in the downstream
physical hardware of the cable interface.
Chapter 6
Cable CPE Commands
OL-1581-07
Advertisement
Table of Contents
