Table of Contents
Advertisement
debug cr10k-rp
PRE REDUNDANCY: Send bulk sync ack failed
PRE RF: Waiting for bulk sync ack
PRE REDUNDANCY: Bulk sync completed
PRE REDUNDANCY: Recv bulk sync complete - sending ack
PRE REDUNDANCY: Send bulk sync ack failed
PRE RF: Waiting for bulk sync ack
The following example shows the typical messages for the ha-recovery option. The following messages
show the typical recovery process, in which cable modems with active voice calls are recovered first.
After these cable modems are online, the remaining, data-only cable modems are recovered.
PRE_RECOVERY: <Cable I/F> Received message to recover voice
PRE_RECOVERY: Suspending recovery until higher priority modems are recovered
PRE_RECOVERY: All interfaces recovered. Killing the voice process
PRE_RECOVERY: No events in voice queue. Allow data modems to recover
PRE_RECOVERY: <Cable I/F> Resume data recovery after suspend (modems recovered <# of CMs>)
PRE_RECOVERY:<Cable I/F> Received message to recover data
PRE_RECOVERY: All interfaces recovered. Killing the data process
The following are possible messages that can be displayed because of potential error conditions:
PRE_RECOVERY:<Cable I/F> No modems to be recovered
PRE_HA:<Cable I/F> Unable to start the voice recovery process
PRE_HA: <Cable I/F> Unable to start the data recovery process
Related Commands
Command
debug cable interface
debug cable
mac-address
Cisco Broadband Cable Command Reference Guide
5-96
Description
Enables debugging on a specific cable interface.
Enables debugging for a specific CM, as identified by its hardware (MAC)
address.
Chapter 5
Cisco CMTS Debugging Commands
OL-1581-08
Advertisement
Table of Contents
