Table of Contents
Advertisement
cable upstream equalization-coefficient
Examples
The following example shows how to enable the use of the equalization coefficient on upstream 0 on the
cable interface line card in slot 5/1 on the Cisco uBR10012 router:
Router# configure terminal
Router(config)# interface cable 5/1/0
Router(config-if)# cable upstream 0 equalization-coefficient
Router(config-if)#
Related Commands
Command
cable upstream frequency
cable upstream power-level
Cisco Broadband Cable Command Reference Guide
2-306
Chapter 2
Description
Enters a fixed frequency of the upstream RF carrier for an
upstream port.
Sets the input power level for the upstream RF carrier in
decibels per millivolt (dBmV).
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
