Cisco SR2016T-NA Reference Manual page 1082

show controllers cable-modem classifiers
show controllers cable-modem classifiers
To display the DOCSIS 1.1 classifiers currently in use on the router, use the show controllers
cable-modem classifiers command in privileged EXEC mode.
Cisco uBR905 and uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
Syntax Description number
classifier-id
summary
Command Modes Privileged EXEC
Command History Release
12.2(15)CZ
Usage Guidelines This command displays the classifiers that are currently defined for both the upstream and downstream.
The information shown corresponds to the Quality of Service classifier parameters that are listed in
Appendix C of the DOCSIS 1.1 specification.
Examples The following example shows typical output for both upstream and downstream classifiers on the show
controllers cable-modem classifiers command:
Router# show controllers cable-modem 0 classifiers
Upstream Packet Classifiers parameters
Classifier Reference:
Classifier ID:
Service Flow Reference:
Service Flow ID:
Rule Priority:
Activation State:
Dynsrv Change Action:
SID:
IP classifiers:
ToS:
Protocol:
Source Address:
Source Mask:
Destination Address:
Destination Mask:
Source Port Start:
Source Port End:
Destination Port Start:
Cisco Broadband Cable Command Reference Guide
6-80
show controllers cable-modem number classifiers [classifier-id | summary]
Identifies the cable interface (always 0).
(Optional) Displays information for a specific classifier. The valid range is
1 to 65535.
(Optional) Displays a brief summary of all classifiers.
Modification
This command was introduced for the Cisco uBR905 and Cisco uBR925
cable access routers, and the Cisco CVA122 Cable Voice Adapter.
1
2
1
101
0
1
0
90
0x1 0x3 0xFF
258
0.0.0.0
255.255.255.255
0.0.0.0
255.255.255.255
65
65
0
Chapter 6 Cable CPE Commands
OL-1581-07