Cisco SR2016T-NA Reference Manual page 975

Chapter 5 Cisco CMTS Debugging Commands
debug packetcable all
To display debugging messages for all PacketCable events, use the debug packetcable all command in
privileged EXEC mode. To turn off Packetcable debugging, use the no form of this command.
Syntax Description detail
Command Modes
Privileged EXEC
Command History Release
12.2(8)BC2
12.2(15)BC1
Usage Guidelines This command enables the display of all PacketCable debugging messages, and is equivalent to giving
the other
about a particular event, such as the creation or termination of a call.
In Cisco IOS Release 12.2(15)BC1 and later releases, you must first use the
subscriber
packetcable all command displays any output.
To display detailed debugging output in Cisco IOS Release 12.2(15)BC1 and later releases, use the
Note
verbose option when you enable PacketCable debugging output using the
subscriber
This command can generate a significant amount of debugging information, and the volume of this
Caution
information could impact system performance on active PacketCable networks. Do not use this
command except in lab or test networks, or where the need to troubleshoot problems makes the impact
on system performance acceptable.
OL-1581-08
debug packetcable all [detail]
no debug packetcable all [detail]
Displays additional debug messages for specific events, such as the content
of PacketCable headers and messages.
Note
Modification
This command was introduced for the Cisco uBR7200 series universal
broadband router.
Support was added for the Cisco uBR10012 universal broadband router.
Also, the detail option was removed, and this command now requires that
you enable PacketCable debugging for one or more IP addresses, using the
debug packetcable subscriber
In addition, packetcable gate coordination support was removed for all
platforms because that debugging option was removed from the release.
debug packetcable gate
command to enable PacketCable debugging for one or more IP addresses before the debug
command.
Release 12.2(15)BC1 removed this option and replaced it with the
verbose option of the debug packetcable subscriber
command, before displaying any output.
commands individually. Use this command to get complete debugging
Cisco Broadband Cable Command Reference Guide
debug packetcable all
command.
debug packetcable
debug packetcable
5-115